JVC HR-XVS30E, Instructions Manual, Page: 73 / 84

Masterpage:Right-No-Heading
EN
73
Filename [XVS30EX_10Subsidiary.fm]
Page 73 September 1, 2003 12:30 pm
Set Stations (A)
Set station names that are registered in your unit.
A
Select the item.
Press
rt w e
until the item you want begins blinking.
B
Access the Manual Channel Set screen.
Press OK twice.
C
Select the new station.
D
Switch the stations.
Press OK .
●
The Confirmation screen appears.
●
Repeat steps
A
–
D
as necessary.
E
Close the Confirmation screen.
Press SET UP MENU .
Set Stations (B)
Set station names other than the ones registered in your unit.
A
Select the character for station name.
B
Enter the new character.
Press
rt
to cycle through the characters (A–Z, 0–9, –,
f
, +,
I
(space) ) and stop when the desired character is
indicated, then press
e
to enter. Enter the remaining
characters the same way (maximum of 4). After entering
all characters, press
OK .
●
The Confirmation screen appears.
●
If you make a mistake, press
w
until the incorrect character
begins blinking. Then enter the correct character by pressing
rt
.
C
Close the Confirmation screen.
Press SET UP MENU .
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
–,
f
, +,
I
(space) (maximum of 4).
Fine-Tuning Channels Already Stored
A
Select the channel to fine-tune.
Press
rt w e
until the channel you want to tune begins
blinking.
B
Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C
Perform tuning.
Press
e
until “+/–” begins blinking, then press
rt
until
the picture is its clearest. Then press OK .
●
The Confirmation screen appears.
●
Repeat steps
A
–
C
as necessary.
D
Close the Confirmation screen.
Press SET UP MENU .
Perform steps
A
and
B
of “Manual Channel Set” on page 71
to access the Confirmation screen before continuing.
Press
e
until the station
name (ID) begins blinking,
then press
rt
until the new
station’s name (ID) you want
to store begins blinking.
Registered station names
(
墌
pg. 74) appear as you
press
rt
.
Perform steps
A
and
B
of “Manual Channel Set” on page 71
to access the Confirmation screen and then perform steps
A
and
B
of “Set Stations (A)” above before continuing.
Press
e
until the first letter of
the station name begins
blinking.
Perform steps
A
and
B
of “Manual Channel Set” on page 71
to access the Confirmation screen before continuing.
XVS30EX_01.book Page 73 Monday, September 1, 2003 12:31 PM