Operations on
VCR Deck
Operations on
DVD Deck
Advanced Operations
Additional Information
Introduction
Preparation
9
Operations on
VCR Deck
Operations on
DVD Deck
Advanced Operations
Additional Information
Introduction
Preparation
9
~
Place the unit on a stable, horizontal surface.
Ÿ
Connect the unit to TV.
RF Connection
1
Disconnect the TV antenna from the TV.
2
Connect the TV antenna cable to the VHF/UHF
IN connector on the rear panel of the unit.
3
Connect the supplied RF cable between the
VHF/UHF OUT connector on the rear panel of
the unit and the TV’s antenna terminal.
AV Connection
1
Connect the antenna, unit and TV as per “RF
Connection.”
2
Connect an optional audio/video cable between
the AUDIO/VIDEO OUTPUT connectors on the
rear panel of the unit and the TV’s audio/video
input connectors.
• Set your TV to AV mode.
!
Plug the end of the AC power cord into an AC outlet.
This unit performs Plug&Play Set automatically. (
☞
pg. 11)
The clock and tuner channels will automatically be
set when the antenna is connected and when the
AC power cord is connected to an AC outlet for the
first time. (If “Auto” and the channel indicator are
displayed on the front display panel before the unit is
powered on, the clock and tuner channels are being
set automatically. Wait for the time to be displayed
on the front display panel before turning on the unit.)
⁄
Set the VCR channel.
The VCR channel is the channel on which you can
watch the picture from the unit on the TV only when
using RF connection. With RF connection, set the
VCR channel to “3 CH” or “4 CH.”
• The VCR channel is preset to “3 CH.” Set to “4 CH” if
the Channel 3 is used for broadcasting in your area.
• With AV connection, set the VCR channel to “– CH”
(off).
To set the VCR channel, perform the following steps:
Before performing the following steps:
•
Make sure there is no cassette inserted in the unit.
• Make sure the unit is turned on, then press
VCR/DVD
on the unit so that the VHS indicator
lights up on the front display panel.
1
Press
POWER
on the unit to turn off the unit,
then press
7
STOP
on the unit for more than 5
seconds. “3 CH” appears on the front display
panel.
2
Press
CH +/–
on the unit to select “3 CH,” “4 CH,”
or “– CH” (off), then press
POWER
on the unit.
Connections
Basic Connections
Antenna or Cable
Coaxial cable
Flat feeder
AC Outlet
Matching transformer
(not supplied)
AC Power Cord
VIDEO OUTPUT
VHF/UHF OUT
AUDIO
OUTPUT
VHF/UHF
IN
Back of unit
Audio/video cable
(not supplied)
To Audio/video
input connectors
RF cable
(supplied)
To 75 ohm
Terminal
TV
04-11_HR-XVC32SUJ.indd 9
04-11_HR-XVC32SUJ.indd 9
05.4.21 6:30:05 PM
05.4.21 6:30:05 PM
