40
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to 8
shows, as far as a year in advance. Remember, the clock must
be set before you can program the timer (
Z
pg. 7 or 9).
Or you can use the Illumi-Guide feature, where the remote
control tells you which button to press next by lighting it up. To
use the Illumi-Guide feature, with the TV/CABLE/VCR switch
set to "VCR", press ILLUMI GUIDE before performing step 2.
(MENU, REW, PLAY, FF light up at this time.)
If you aren't going to use the Illumi-Guide feature, go directly to
step 1.
On-Screen
Timer
Programming
6
q
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load.
●
The VCR comes on, and the counter is reset,
automatically.
●
If watching channel 3 or 4, press TV/VIDEO to select
the VIDEO mode. VIDEO is displayed on the front
display panel.
ACCESS ON-SCREEN
MENU
2
Press MENU as many times as necessary to bring up the
Main Menu screen.
●
If you are using the Illumi-Guide feature, MENU
lights up and OK blinks.
ACCESS PROGRAM SET
SCREEN
3
Make sure the arrow is to
the left of "PROGRAM
SET", then press OK.
●
If you are using the
Illumi-Guide feature, OK
blinks when the
following buttons are lit:
NUMBER keys (0 – 9),
SHUTTLE PLUS, CANCEL and MENU.
SELECT PROGRAM
NUMBER
4
Press the appropriate NUMBER keys or CH
5∞
or
SHUTTLE PLUS
5∞
to select a vacant program number,
then press OK. The first time you do this, all numbers will
be vacant, so just press OK when the screen appears.
●
If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys (0
– 9), SHUTTLE PLUS, CANCEL and MENU.
PROGRAM 1
DATE - - / - -
START - - : - - AM
STOP - - : - - AM
CHANNEL - - SP
PRESS NUMBER KEY(0-9)
OR (
5
,
∞
), THEN (OK)
PRESS (MENU) TO END
1
2
4
5
3
6
8
0
7
9
CH
OK
SHUTTLE PLUS
MENU
NUMBER
ILLUMI GUIDE
When Using The Illumi-Guide Feature
●
Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
●
If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.
MENU
OK
CH
Summary of Contents for HR-VP639U
Page 63: ...63 MEMO ...
