JVC HR-S5700AM, Instructions Manual

Page: 31 / 60

EN
31
When programmes overlap
each other
If “PROGRAM OVERLAPPED” appears, you have another
programme overlapping the programme you have just made.
The Programme Check screen appears and conflicting
programmes will start blinking.
Example: Programme 1 (you have just made) and Programme 4
overlap each other.
1 2 3
4 5 6
7
8 9
0
1
2
4
3
START+/–
DATE+/
–
STOP+/
–
OK
PUSH JOG
SP/LP/EP
PROGRAM OVERLAPPED
PR START STOP CH DATE
1 8:00 10:00 3 24.04
2 10:00 10:45 2 25.04
3 11:30 13:00 1 25.04
4 9:00 10:00 92 DAILY
5
6
7
8
[
5
/
∞
]
=
[PROG] : EXIT
CONFIRM THE OVERLAP-
PING PROGRAMMES
1
Overlapping programmes blink on the TV screen.
SELECT THE PROGRAMME
TO MODIFY
2
Press PUSH JOG
%fi
, then press OK or PUSH JOG .
●
You can only select one of the overlapping
programmes.
NOTE:
If you do not mind this overlap, press PROG to finish the
timer programme setting. The programme with the lower
programme number will be recorded and the other one
will not be recorded correctly. If no changes are made
for approximately 1 minute, the recorder will return to
the normal screen.
CANCEL OR CHANGE
PROGRAMME SETTING
3
To cancel a programme, press when the Programme
screen you do not want is shown. “PROGRAM
COMPLETED” appears on the TV screen for about 5
seconds, then the normal screen appears.
To change a programme, press the appropriate button:
START+/- , STOP +/- , DATE+/- , PR+/- and/or SP/LP/EP
( ) when the Programme screen on which you want
to make changes is shown, then press OK . “PROGRAM
COMPLETED” appears on the TV screen for about 5
seconds, then the normal screen appears.
NOTE:
If the overlap is not yet solved, or another overlap occurs
with the timer programme setting after making the last
correction on a programme, the conflicting programmes
will be shown on the Programme Check screen again.
Repeat the above steps again until the overlap is solved.
%
PR +/–