1-6 (No.YF227<Rev.001>)
2.3
SERVICE FOR EVERIO DOCK (CU-VD4)
2.3.1 Service repair parts
This unit mainly consists of CABINET PARTS and two BOARD
ASSYS.
The main service repair parts are as follows.
For details of service repair parts, please refer to the parts list.
• CABINET PARTS
• BOARD ASSYS
(CDL JACK BOARD ASSY & CDL CN BOARD ASSY)
• Some electrical parts
2.3.2 Disassembly
1. Removing the TOP CASE (Refer to Fig.2-3-1)
Remove the 4 screws (1-4), and then remove the TOP CASE.
2. Removing the HOLDER (Refer to Fig.2-3-2)
Take out the CDL CN BOARD ASSY from the BOTTOM
CASE.
Pull out the HOLDER from the connector by releasing the 4
hooks holding the HOLDER one by one.
Note) During the procedure, be careful in handling the
SPRING.
3. Removing the SPRING (Refer to Fig.2-3-3)
Release the CDL CN BOARD ASSY as shown in the figure,
and take out the SPRING from the BOTTOM CASE.
4. Removing the CDL CN BOARD ASSY/ CDL JACK BOARD
ASSY (Refer to Fig.2-3-4)
Release the lock of CN2, and remove the CDL CN BOARD
ASSY while pulling out the FPC.
Release one hook, and remove the CDL JACK BOARD ASSY.
