JVC GR-FX60, Instructions Manual

Page: 61 / 76

EN
61
M 0 : 12 : 34
Insert Editing (Insert A Still Image From
The Built-in Memory Onto A Tape)
You can insert a still image stored in the camcorder's built-
in memory into a previously recorded tape, replacing a
section of the original recording with minimal picture
distortion at the in- and out-points. The original audio
remains unchanged.
Perform steps 1 through 5 in Insert Editing (VIDEO)
(
Z
pg. 60) before the following procedure.
NOTE:
Use the RM-V709U remote control unit to perform this
procedure.
1
SELECT STILL IMAGE
First set the System Select Switch to “D.S.C.”. Press
REW (
2
/PAGE–) or FF (
3
/PAGE+) to select the
still image you wish to insert.
2
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches
“0:00:00”, editing stops automatically and the
camcorder enters the Insert-Pause mode.
To insert still images in sequential order onto the
tape . . .
... press REW (
2
/PAGE–) or FF (
3
/PAGE+) to
move the page forward.
To insert still images at random onto the tape . . .
... first record the still image you selected in step 1
onto the tape, then press START/STOP to engage
the Insert-Pause mode. To select another still
image, press REW (
2
/PAGE–) or FF (
3
/
PAGE+) again, then press START/STOP. Insert-
Editing begins.
3
END INSERT EDITING
Press STOP.
NOTES:
●
The tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
●
Only video signal is recorded in the Insert Editing mode.
REW
Insert editing
indicator
Display
COUNTER R/M Button
Tape counter
REW (
2
/PAGE–) Button
FF (
3
/PAGE+) Button
PLAY/PAUSE (
4
/
6
) Button
STOP (
5
) Button
START/STOP
PLAY
Remote sensor
Power Switch
System Select Switch
STOP
INSERT
RM-V709U
(provided)
PAUSE