EN
45
I T E M S
N O T E S
❍
When the Power Switch is set to “
” or “
” and the LCD
monitor is opened at an angle of 60 degrees or more, the LCD
monitor switches on and the viewfinder switches off automatically
to save power (models equipped with LCD monitor only).
❍
The cassette holder cannot be opened unless a power supply is
attached.
❍
There may be a delay after you slide
EJECT
until the cassette holder
opens. Do not use force.
❍
The time required to calculate the remaining tape length, and the
accuracy of the calculation, may vary according to the type of tape
used.
❍
The tape remaining time indicator is correct only if the correct tape
length has been selected (
墌
pg. 12).
❍
“TAPE END” appears when the tape reaches its end, and the power
goes off automatically if left in this condition for 5 minutes.
“TAPE END” also appears when a cassette whose tape is already at
its end is loaded.
❍
If the Recording Start/Stop button is pressed after the Record-
Standby mode has continued for over 5 minutes, recording may not
start immediately.
❍
While shooting, sound is not heard from the speaker (models
equipped with LCD monitor only).
❍
The “TBC” indicator turns green (grey with a camcorder equipped
with a black/white viewfinder) while TBC is working.
❍
TBC does not work during still playback and shuttle search.
❍
The “TBC” indicator turns white while TBC is not operative.
❍
It may take a few seconds before TBC actually starts working.
❍
The picture may be distorted if the TBC mode is activated or
deactivated at the edit-in/-out points or when normal playback
resumes after still playback or shuttle search.
❍
If the playback picture is distorted when TBC is set to on, turn off
TBC.
➪
TBC
(Time Base
Corrector)
(
墌
pg. 31)
➪
Recording
(
墌
pg. 14, 15)
