JVC GR-DA20EK, Instructions Manual

Page: 17 / 40

EN
17
MasterPage: Start_Right
Recording & Playback
EN
GL
IS
H
●
You can zoom in up to 34X by using the optical
zoom.
●
Zoom magnification over 34X is done through
digital image processing, and is therefore called
digital zoom. Digital zooming is possible up to
800X. Set (ZOOM) to [68X] or [800X]. (
墌
22)
Notes:
●
Macro shooting is possible as close as approx.
5 cm to the subject when the zoom lever is set
all the way to “W”.
●
When you zoom into a subject close to the lens,
the camera may automatically zoom out
depending on the distance to the subject. In this
case, set
“TELE MACRO”
to
“ON”
. (
墌
22)
During recording, a time code is recorded on
the tape. This code is to confirm the location of
the recorded scene on the tape during
playback.
* Frames are not displayed during recording.
If recording starts from a blank portion, the time
code begins counting from “00:00:00”
(minute:second:frame). If recording starts from
the end of a previously recorded scene,
the time code continues from the last time code
number. If during recording a blank portion is
left partway through the tape, the time code is
interrupted. When recording is resumed, the
time code starts counting up again from
“00:00:00”. This means the camcorder may
record the same time codes as those existing
in a previously recorded scene. To prevent this,
perform “Recording From The Middle Of A
Tape”
(
墌
17) in the following cases;
●
When shooting again after playing back a
recorded tape.
●
When power shuts off during shooting.
●
When a tape is removed and re-inserted during
shooting.
●
When shooting using a partially recorded tape.
●
When shooting on a blank portion located
partway through the tape.
●
When shooting again after shooting a scene
then opening/closing the cassette holder cover.
Notes:
●
The time code cannot be reset.
●
During fast-forwarding and rewinding, the time
code indication does not move smoothly.
●
The time code is displayed only when “TIME
CODE” is set to “ON”. (
墌
23)
Play back a tape or use Blank Search
(
墌
19) to find the spot at which you want to
start recording, then engage the Still
Playback mode (
墌
18).
Set the Power Switch to “REC” (
墌
11),
then start recording.
Zoom
Time Code
– VOL.+
T W
Zoom out Zoom in
T: Telephoto
W: Wide angle
800
34
Optical zoom (up to 34X)
Digital zoom (up to 800X)
12 : 34 : 24
Minutes
Seconds
Frames*
(25 frames = 1 second)
Display
Recording From The Middle Of A Tape
1
2
GR-DA20EK.book Page 17 Thursday, August 2, 2007 12:08 PM