JVC GR-D770AG, Instruction Manual

Page: 36 / 52

MasterPage: Heading0_Left
36
EN
FEATURES FOR RECORDING
LED Light can be used to
brighten the subject in the dark
place during video recording or
D.S.C. shooting.
1
Press LIGHT repeatedly to change the
setting.
2
Press the Recording Start/Stop Button to
start video recording or SNAPSHOT to shoot a
still image.
NOTES:
●
Be careful not to point the LED Light directly to
eyes.
●
If the light does not reach the subject when the
LED Light setting is “ON”, the Night-Scope
function will be activated, and makes it possible
to shoot the subject brighter.
●
Since subjects are shot at a reduced shutter
speed when the LED Light setting is “ON”, they
will appear slightly blurred
.
This feature is useful for recording or playing
back precious or hard-to-see moments at a
slow speed. Sound is recorded and played
back in real time.
1
Set the VIDEO/MEMORY Switch to
“VIDEO”.
2
Set the Power Switch to “REC” or “PLAY”.
●
If set to “REC”, the recording mode should be
set to
“
M
” . ( pg. 20)
3
Set “SNAP/SLOW” to “SLOW”.
( pg. 33, 35) The Live Slow indicator “ ”
appears.
4
Press SLOW during recording or playback.
●
The moving pictures are divided into four
frames. They are recorded or played back for
1.5 seconds, and then normal recording or
playback resumes.
NOTES:
●
This feature is effective when the recording
mode selection is set to both “
A
” or “
M
”.
●
Live Slow cannot be used when the 16:9 Wide
mode is selected.
This feature lets you record still images that
look like photographs onto a tape.
1
Set the VIDEO/MEMORY Switch to
“VIDEO”.
2
Set the Power Switch to “REC”.
3
Set the recording mode to “
M
”. ( pg. 20)
4
Set “SNAP/SLOW” to “SNAP”.
( pg. 33, 35)
5
Set “REC SELECT” to
“ / ” or
“ ”. ( pg. 33)
6
Press SNAPSHOT .
●
The
“PHOTO
” indication appears and a still image
will be recorded for approx. 5 seconds, then the
camcorder re-enters the Record-Standby mode.
●
You can perform Snapshot also during
recording. A still image will be recorded for
approx. 5 seconds, then the normal recording
resumes.
●
Snapshot is effective when the recording mode
selection is set to both
“
A
”
or
“
M
”.
●
If the image taken by snapshot is too dark or too
bright, select
( pg. 38) or “SPOTLIGHT”
( pg. 40).
Motor Drive Mode
Keeping SNAPSHOT pressed in step
6
provides an effect similar to serial
photography. (Interval between still
images: approx. 1 second)
●
The Motor Drive mode is disabled when “REC
SELECT” is set to “
/ ” or “ ”.
( pg. 33)
LED Light
The light is on always. ( appears.)
The light turns on automatically
when dark. (
appears.)
Turns off the light.
Live Slow
LED Light
LIGHT
Snapshot (Record Still Image On
Tape)
GR-D770AG_EN.book Page 36 Tuesday, December 5, 2006 1:47 PM