EN
21
VIDEO RECORDING
MasterPage: Start_Right
Time Code
During recording, a time code is recorded on the
tape. This code is to confirm the location of the
recorded scene on the tape during playback.
* Frames are not displayed during recording.
If recording starts from a blank portion, the time
code begins counting from “00:00:00”
(minute:second:frame). If recording starts from
the end of a previously recorded scene,
the time code continues from the last time code
number. If during recording a blank portion is left
partway through the tape, the time code is
interrupted. When recording is resumed, the
time code starts counting up again from
“00:00:00”. This means the camcorder may
record the same time codes as those existing in
a previously recorded scene. To prevent this,
perform Recording From The Middle Of A Tape
in the following cases;
●
When shooting again after playing back a
recorded tape.
●
When power shuts off during shooting.
●
When a tape is removed and re-inserted during
shooting.
●
When shooting using a partially recorded tape.
●
When shooting on a blank portion located partway
through the tape.
●
When shooting again after shooting a scene then
opening/closing the cassette holder cover.
NOTES:
●
The time code cannot be reset.
●
During fast-forwarding and rewinding, the time
code indication does not move smoothly.
●
The time code is displayed only when “TIME
CODE” is set to “ON”. (
Recording From The Middle Of A Tape
1)
Play back a tape or use Blank Search
pg. 23) to find the spot at which you want to
start recording, then engage the Still Playback
mode. (
2)
Set the Power Switch to “REC” while pressing
down the Lock Button located on the switch,
then start recording.
Dual Rec.
You can capture still images without disturbing
the recording in progress. Press
SNAPSHOT
.
A sub screen will be displayed for approx. 6
seconds to show you the
snapshot image.
●
The Still image is saved into the memory card
while video is recorded onto the cassette tape.
●
“REC SELECT” must be set to “
(CARD)”.
Auto/Manual Mode
Press
AUTO
button repeatedly to switch to auto/
manual recording mode. When manual mode is
selected, the indicator “
M
” appears on the LCD
monitor.
Auto Mode:
A
You can record using no special effects or
manual adjustments.
Manual Mode:
M
Manual recording is possible by setting various
functions.
12 : 34 : 24
Minutes
Seconds
Frames*
(25 frames = 1 second)
Display
M
GR-D770EK_GR-D760EK_EN.book Page 21 Thursday, December 14, 2006 4:18 PM