40
ENGLISH
SOUND ADJUSTMENTS
Adjusting the sound
You can set the speaker output balance, subwoofer
output level, and input level of each source.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step
1
again.
1
Select the item you want to adjust.
The next-step-operation
buttons start flashing.
Each time you press the
button, the adjustable items
change as follows:
• For iEQ (sound mode) settings,
see pages 41 – 43.
• For THEME (display theme) settings,
see page 44.
Indication
To do:
Range
Fad
Adjust the front
R06 (Rear only)
and rear speaker
|
balance.
F06 (Front only)
Bal
Adjust the left
L06 (Left only)
and right speaker |
balance.
R06 (Right only)
Sub Out
Adjust the
00 (min.)
subwoofer output |
level and cutoff
08 (max.)
frequency level.
Low/Mid/High
Vol Adj
Adjust and store
–05 (min.)
the input level
|
of each source.
+05 (max.)
2
Make adjustments.
• To adjust fader and balance—Fad, Bal:
You can make these two adjustments at
the same time.
• If you are using a two-speaker system,
set the fader level to “00.”
• Press
5
(up) or
∞
(down)
to adjust the fader.
• Press
¢
or
4
to adjust the balance.
• To adjust subwoofer output—Sub Out:
This takes effect only when a subwoofer is
connected.
You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.
• Press
¢
or
4
to select “Low,”
“Mid,” or “High.”
Low:
Frequencies higher than 55 Hz are
cut off to the subwoofer.
Mid:
Frequencies higher than 85 Hz are
cut off to the subwoofer.
High: Frequencies higher than 115 Hz are
cut off to the subwoofer.
To decrease the level
To increase the level
Canceled
Vol Adj
Fad/Bal
Sub Out
iEQ
Theme
EN40-44_KD-LHX601[E_EX].p65
04.1.15, 2:32 PM
40