1-18 (No.MB544)
3.2.4 Removing the DVD module board
(See Figs.5 and 6)
• Remove the clamper base and traverse mechanism assembly.
(1) Solder the short land sections
b
on the DVD pickup. (See
Fig.5.)
Caution:
• Solder the short land sections
b
on the DVD pickup be-
fore disconnecting the card wire from the connector
CN101
on the DVD module board. If the card wire is
disconnected without attaching solders, the DVD pick-
up may be destroyed by static electricity. (See Figs.5
and 6.)
• When attaching the DVD module board, be sure to re-
move solders from the short land sections
b
after con-
necting the card wire to the connector
CN101
on the
DVD module board. (See Figs.5 and 6.)
(2) Release the lock of the connector
CN101
on the DVD mod-
ule board in the direction of the arrow and disconnect the
card wire. (See Fig.6.)
(3) Remove the spacers on the DVD module board. (See
Fig.6.)
(4) Remove the two screws
D
attaching the DVD module
board. (See Fig.6.)
(5) Disconnect the card wire from the connector
CN201
on the
DVD module board. (See Fig.6.)
(6) Remove the DVD module board from the engagement sec-
tion
c
in an upward direction and remove it from the hook
d
in the direction of the arrow. (See Fig.6.)
Fig.5
Fig.6
Traverse mechanism assembly
DVD pickup
b
Card wire
CN101
CN201
Card wire
c
d
D
D
DVD module board
Spacer
Spacer
Summary of Contents for EX-D11A
Page 43: ... M E M O ...
