72
EN
Master Page: Left
GR-DVP7-5EG_37-79.fm
Page 72
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
NOTES:
●
Before performing the following steps, make sure
that “TIME CODE” is set to “ON”. (
墌
pg. 38, 48)
●
Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
●
To perform Insert Editing while watching in the
television, make connections. (
墌
pg. 24, 25)
1
Play back the tape, locate the Edit-Out point and
press
PAUSE
(
9
). Confirm the time code at this
point. (
墌
pg. 38, 48)
2
Press
REW
(
3
) until the Edit-In point is located,
then press
PAUSE
(
9
).
3
Press and hold
INSERT
(
I
) on the remote
control, then press
PAUSE
(
9
). The “
9
I
”
indicator and the Time
Code (min.:sec.)
appear and the
camcorder enters
Insert-Pause mode.
4
Press
START/STOP
to begin editing.
●
Confirm the insert at the time code you
checked in step
1
.
●
To pause editing, press
START/STOP
. Press it
again to resume editing.
5
To end Insert Editing, press
START/STOP
, then
STOP
(
8
).
NOTES:
●
Program AE with special effects (
墌
pg. 38, 41)
can be used to spice up the scenes being edited
during Insert Editing.
●
During Insert Editing, the date and time
information changes.
●
If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
●
During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Edting stops. (
墌
pg. 100, 101)
Insert Editing
PAUSE
START/STOP
INSERT
PLAY
REW
STOP
Remote sensor
12 : 34
9
I
USING THE REMOTE CONTROL UNIT (cont.)
GR-DVP7-5EG_02-08.book Page 72 Thursday, February 28, 2002 11:39 AM
