JVC DR MV79B - DVDr/ VCR Combo, Instructions Manual

Page: 22 / 306

18
Audio Settings
Audio Settings
Each DVD disc has a variety of audio output options.
Set the Recorder’s Audio Output according to the
type of audio system you use.
Dolby Digital / DTS / MPEG
[Bitstream]: Select [Bitstream] if you connect the
DVD+VCR’s DIGITAL AUDIO OUTPUT jack to an
amplifier or other equipment with a Dolby Digital,
DTS or MPEG decoder.
[PCM] (for Dolby Digital / MPEG): Select when
connected to a two-channel digital stereo amplifi-
er. DVDs encoded in Dolby Digital or MPEG will
be automatically downmixed to two-channel PCM
audio.
[OFF] (for DTS): If you select [OFF], the DTS
signal is not output through the DIGITAL AUDIO
OUTPUT
Sampling Freq. (Frequency)
If your receiver or amplifier is NOT capable of han-
dling 96 kHz signals, select 48 kHz. When this choice
is made, this unit automatically converts any 96 kHz
signals to 48 kHz so your system can decode them.
If your receiver or amplifier is capable of handling 96
kHz signals, select 96 kHz. When this choice is
made, this unit passes each type of signal through
without any further processing.
Check the documentation for your amplifier to verify
its capabilities.
DRC (Dynamic Range Control)
With the DVD format, you can hear a program’s
soundtrack in the most accurate and realistic presen-
tation possible, thanks to digital audio technology.
However, you may wish to compress the dynamic
range of the audio output (the difference between the
loudest sounds and the quietest ones). This allows
you to listen to a movie at a lower volume without los-
ing clarity of sound. Set DRC to [ON] for this effect.
Lock (Parental Control) Settings
Lock (Parental Control) Settings
OR
[US Rating] [Canadian Rating]
Notes:
• Lock System and TV Rating options are effective for
digital TV program only.
• When you set the TV Rating, a program with a TV
Rating beyond your rating setting cannot be recorded
correctly. (Normal recording, Timer recording, etc.)
• The default TV Rating setting is to allow all programs
to be viewed.
Lock System
You can lock certain unsuitable channels to prevent chil-
dren from accessing them, or set a TV Rating, so that
any digital TV program classified above that rating by
the broadcaster will be restricted. If the [Lock System] is
set to [OFF], TV Rating options are not effective.
The Lock System option is effective for TV Rating and
Downloadable Rating options.
1. Select [Lock System] option then press
B .
2. To access the Lock Menu options, you must input
the 4-digit password you created.
If you have not yet entered a password you are
prompted to do so. Input a 4-digit password. Enter it
again to verify. If you make a mistake, press CLEAR.
3. Select [ON] or [OFF] using the v / V buttons.
4. Press ENTER to confirm your setting.
Set Password
You can enter or change password.
1. Select [Set Password] option then press
B .
2. Follow step 2 as shown in [Lock System] above.
To change the password, press ENTER when the
[Change] option is highlighted, then input old pass-
word. Input new password. Enter it again to verify.
To delete the password, select [Delete] option then
press ENTER, then input old password. The pass-
word is deleted.
3. Press HOME to exit the menu.
If you forget your password
If you forget your password you can reset it using the
following steps:
1. Press HOME and the Home menu appears.
2. Select [Setup] > [Start] and press ENTER.
3. Input the 6-digit number [210499]. When the mes-
sage appears, select [OK] then press ENTER. The
password will be reset.
4. Enter a new password as described above.