VS-DT2000
1-8
Fig.5
Fig.6
Fig.7
CD mechanism
assembly
CN801
LED board
Push button
D
D
G
F
D
Claw
c
Claws
d
CN171
CN182
Wire holder
Bottom chassis
Front panel assembly
Claws
d
Main board
Tie band
CN183
CN106
Hole on
the bottom chassis
Front panel assembly
E
[Reference]
Before attaching the front panel assembly,
pass the card wire of the front panel assembly
through the hole on the bottom chassis.
After attaching the front panel assembly,
bundling the card wire and wires of the front
panel assembly using a wire holder and tie
band.
Removing the CD mechanism
assembly (See Fig. 5.)
1.
2.
3.
4.
From the top side of the main body, disengage the
claw
c
of the CD mechanism assembly and then
remove the push button.
Remove the five screws
D
, screw
E
and screw
F
attaching the CD mechanism assembly.
Disconnect the wire from connector CN801 on the
LED board.
Remove the CD mechanism assembly in an
upward direction.
Removing the front panel assembly
(See Figs. 6 and 7.)
1.
2.
3.
4.
5.
6.
Remove the tie band bundling the wires of the front
panel assembly.
Disconnect the wires from connectors CN106 and
CN182 on the main board.
Disconnect the card wires from connectors CN171
and CN183 on the main board.
Remove the wire holder holding the card wire of
the front panel assembly.
From the front side of the main body, remove the
two screws
G
attaching the front panel assembly.
Disengage the claws
d
of the front panel assembly
from the bottom chassis and then remove the front
panel assembly in the direction of arrow.
Remove the top lens.
Remove the bottom panel.
Remove the top panel.
Remove the top lens.
Remove the bottom panel.
Remove the top panel.
Remove the CD mechanism assembly.
Summary of Contents for CA-VSDT2000R
Page 60: ...VS DT2000 3 2 M E M O ...