(No.MB429)1-9
3.1.4 Removing the CD mechanism assembly
(See Fig.11 to 13)
• Prior to performing the following procedure, remove the front
panel assembly, the main board and the CD mechanism as-
sembly.
Caution:
Before disconnecting the card wire from connector
CN601
on
the CD mechanism board and from CD pickup board, solder
the short-circuit point on the CD pickup board. If you do not fol-
low this instruction, the pickup may be damaged.
(1) Disconnect the wire from connector on the CD motor
board.
(2) Remove the four screws
J
attaching the CD mechanism
board.
(3) Move the CD mechanism board temporarily as shown in
Fig.12.
(4) Remove the screw
K
attaching the wire to the CD mecha-
nism.
(5) Solder the short-circuit point on the CD pickup board.
(6) Disconnect the card wire from connector
CN601
on the CD
mechanism board.
Caution:
Make sure to unsolder the short-circuit point after reconnecting
the card wire to the CD pickup board and to connector
CN601
on the CD mechanism board.
Fig.11
Fig.12
Fig.13
CD mechanism assembly
CD mechanism board
CN601
Wire
J
J
CD mechanism assembly
CD motor board
CD mechanism board
wire
Cord wire
CN601
Short-circuit point
K
Short-circuit point
Card wire
Unsolder
CD pickup board
