JVC CA-FSY1, Instructions Manual

Page: 83 / 174

37
Reference
English
When you encounter a problem that seems to be a
fault, check the following points before contacting
your JVC service center.
Power source
7
Power does not come on.
• The power cord is not connected to the main
unit or an AC outlet.
→
Connect the power cord correctly
(page 11).
Operation
7
You cannot operate any button.
• Some specific operations may be inhibited
for some discs.
7
The remote control does not work.
• The dry-cell batteries have run out.
→
Replace the batteries (page 6).
7 A disc cannot be played back.
• In the case of DVD VIDEO discs
→
Check the Region Code number of the
discs (page 3).
• “NO PLAY” is displayed on the display
window.
It is not a disc that can be played on this
system.
→
Check the disc type (page 3).
• Parental Lock is set (page 30).
About images
7
No picture appears.
• The video cord is not connected correctly.
→
Page 11
• Both of the component video jack and S-
video jack are connected.
→
Connect either (page 11).
7
The picture is distorted.
• A VCR is connected between the main unit
and the TV set.
→
Connect the main unit directly to the TV set
(page 11).
• Although this system is connected to a non-
Progressive TV set, DVD’s scan mode is set
to “PROGRESSIVE”.
→
Set the scan mode to “INTERLACE”
(page 26).
7
The screen size is abnormal.
• The screen size is set improperly.
→
Set “MONITOR TYPE” according to the TV
set you are using (page 29).
7 The TV screen darkens.
• “SCREEN SAVER” is set.
→
If set, press any button (page 29).
7
The screen cannot be switched.
• The Progressive mode is applied only to
component video output.
About sound
7
There is no sound.
• Speakers are not connected correctly.
→
Page 9
• The sound is muted.
→
Page 16
• “NO AUDIO” is displayed on the display
window.
The disc may have been produced through
illegal copying.
→
Confirm at the store where you bought the
disc.
7 The sound is weak compared with TV or Video.
• “DVD LEVEL” is set to “NORMAL”.
→
Set to other than “NORMAL” (page 26).
7
The sound is distorted.
• The volume is turned up too high.
→
Turn down the volume (page 16).
7
No sound comes out of the subwoofer.
• “SUBWOOFER” is turned off.
→
Press S.WFR OUT to turn on (page 10).
About radio
7
The sound is noisy while receiving/Receiving
is disabled.
• The antenna is not connected correctly.
→
Connect the antenna correctly (page 8).
Troubleshooting
FS-Y1[US]main.book Page 37 Monday, February 28, 2005 5:53 PM