JVC CA-FSX1, Service Manual

Page: 16 / 71

1-16 (No.MB004)
3.2.6 Removing the CD door LED board
(See Fig.22)
• Prior to performing the following procedures, remove the CD
mechanism assembly, CD door mechanism assembly and CD
door assembly.
(1) From the reverse side of the CD door assembly, remove
the five screws X attaching the CD door cover.
(2) Remove the screw X attaching the CD door LED board.
(3) After removing the CD door cover, remove the CD door
LED board from the projections ( s , t ) and take out it in the
direction of the arrow.
Fig.22
3.2.7 Removing the front holder assembly
(See Fig.23)
• Prior to performing the following procedures, remove the CD
mechanism assembly.
(1) From the inside of the top case assembly, remove the two
screws Y attaching the front holder assembly.
(2) Take out the front holder assembly.
Fig.23
3.2.8 Removing the front board
(See Fig.24)
• Prior to performing the following procedures, remove the CD
mechanism assembly and front holder assembly.
(1) From the forward side of the front holder assembly, remove
the three screws Z attaching the front board.
Reference :
• Remove the card wire from the connector CN731 on the
front board as required.
• Before attaching the front board, pass the card wire through
the hole u on the front holder assembly.
Fig.24
X
X
CD door
Projection s
Projection t
X
CD door
LED board
CD door cover
Top case assembly
Front holder assembly
Y
Z
Z
Z
Hole u
Front board
Front holder assembly
Card wire
CN731