1-36 (No.MB368)
3.2.14 Removing the sensor board and SV resistor
(See Fig.33)
• Remove the tray assemblies, side (L), side (R) assembly and
lifter assembly.
(1) Remove the solders from the soldered sections
aj
on the
sensor board and remove the wires.
(2) Remove the two screws
Q
and take out the sensor board
with the SV resistor.
Reference:
• Remove the soldered section
ap
on the sensor board as re-
quired.
• When reassembling, pass the wires through the slot
ak
of
the sensor board as before.
Note:
When reattaching the SV. resister, fit the projection am on the
bottom of the SV. resister into slot
an
of the sensor slider.
Fig.33
Q
Q
ap
Sensor board
ak
SV resistor
am
an
SV resistor
Slider
aj
