1-6 (No.YA093)
SECTION 3
DISASSEMBLY
3.1
DISASSEMBLY PROCEDURE [AV-32S565]
3.1.1 REMOVING THE REAR COVER
• Unplug the power plug.
(1) Remove the 14 screws
[A]
as shown in Fig.2.
(2) Remove the REAR COVER toward you.
NOTE:
When reinstalling the REAR COVER, carefully push it inward
after inserting the chassis into the REAR COVER groove.
3.1.2 REMOVING THE SPEAKER
• Remove the REAR COVER.
(1) Remove the 2 screws
[C]
as shown in Fig.2, then remove
the SPEAKER HOLDER.
(2) Remove the 2 screws
[D]
as shown in Fig.2, then remove
the SPEAKER.
(3) Follow the same steps when removing the other hand
SPEAKER.
3.1.3 REMOVING THE AV TERMINAL BOARD
• Remove the REAR COVER.
(1) Remove the 3 screws
[B]
as shown in Fig.2.
(2) Withdraw the AV TERMINAL BOARD toward you.
3.1.4 REMOVING THE CHASSIS
• Remove the REAR COVER.
(1) Slightly raise the both sides of the CHASSIS by hand and
remove the 2 claws under the both sides of the CHASSIS
from the front cabinet.
(2) Withdraw the CHASSIS backward.
(If necessary, remove the wire clamps, connectors etc.)
3.1.5 REMOVING THE CONTROL BASE
• Remove the REAR COVER.
Remove the CHASSIS.
(1) While pushing down the claws
[b]
as shown in Fig.1.
(2) Remove the CONTROL BASE in the arrow direction
marked
[c]
.
( If necessary, remove the wire clamps, connectors etc. )
Fig.1
3.1.6 CHECKING THE PW BOARD
• To check the PW Board from backsid.
(1) Pull out the CHASSIS. (Refer to REMOVING THE
CHASSIS).
(2) Erect the CHASSIS vertically with the HVT side facing up
so that you can easily check the back side of the PW
Board.
CAUTION:
• When erecting the CHASSIS, be careful so that there will be
no contact with other PWB.
• Before turning the power on, make sure that the CRT earth
wire and other connectors are properly connected.
3.1.7 WIRE CLAMPING AND CABLE TYING
(1) Be sure to clamp the wire.
(2) Never remove the cable tie used for tying the wires
together.
Should it be inadvertently removed, be sure to tie the wires
with a new cable tie.
b
c
CONTROL
BASE
CHASSIS
BASE
CLAW
Summary of Contents for AV-32S565 Series
Page 1: ......
Page 107: ...2 35 No YA093 FRONT PATTERN DIAGRAMS MAIN PWB PATTERN SOLDER SIDE ...
Page 108: ... No YA093 2 36 ...
