Juta MPPT-10 User Manual Download Page 3

could  not  normal working.  This  is  normal  phenomenon.  When  the  battery  voltage 

recover to 12.6V or (25.2v), the Load will be automatically working, at this time the 

indicator is off. 

3.  Charge Indicator, green, bright indicate the battery need to charge, flickering means 

float charging, off means charge has stop. 

 

RESET Button: 

The rated output current of this MPPT solar charge controller is 10A, if 

there is short circuit or overload happened, the MPPT controller will close output. ( Load 

indicator off, Low voltage indicator off.) 

If you need the MPPT controller recover work, please check the reasons and clear out the 

fault firstly. Then put a small stick such as toothpick, ball-pen tip inside the RESET hole, 

and press RESET button will be OK. 

Attention: 

1.  Please check the rated voltage of the solar panel, battery, load are all the same 

with 12V or 24V or 48V. 

2.  Please pay attention to connection, 

the best way is that 

do not connect the “+” 

“-”  poles  of  battery  wrong, 

never  connect  “+”  “-”  poles  of

  Loads  and  solar 

panels wrong.( Wrong connection 

will be possible

 burn your MPPT controller) 

3.  Battery must be connected earlier than solar panels and load. When take off the 

system, Solar Panels must be take down first, then cut off battery. 

4.  The rated current of solar panel and load must be less than MPPT controller’s 

rated current. 

 

Reviews: