USE
Before first use, it is recommended you charge the
Power Case via AC power plug (not included). The
Case will take approximately 5.5 hours to charge
from 0-100%.
1. Charging the Power Case:
Plug the supplied Micro USB Charging Cable into
the Case’s Micro USB Input. Insert the USB end of
the cable into a computer or AC power source
with a 5V USB output. The Power Indicator LEDs
will begin flashing. Once fully charged, the LEDs
will remain lit.
Note: It is recommended to keep charging the
Power Case for approximately 1 hour after the
LEDs stop flashing.
2. Inserting iPhone 5s/5 into Power Case:
Place your iPhone into the Power Case by sliding
the Stand Release Button to the left and pulling
the stand forward. Carefully dock your iPhone
onto the Lightning Connector. Clip the stand back
into place.
3. Charging your iPhone 5s/5:
Once your iPhone has been inserted into the
Power Case,
press the Power Button on the
bottom of the Power Case for 3 seconds to
begin charging
. Charging will continue until
your iPhone is fully charged or the Case’s internal
battery has drained.
4. Using the Headphone Jack:
Undock your iPhone from the Power Case. Feed
your headphone jack through the Headphone
Opening, then plug it into your iPhone. Re-dock
your iPhone into the case.
Please note: In some
cases, it is required to use the 3.5mm
Headphone Extension Cable. To use, plug your
headphone jack into the extension cable. Take the
Headphone Extension Cable’s jack and feed it
through the Headphone Opening and plug it into
the iPhone. Re-dock your iPhone into the case.
TROUBLESHOOTING
1. iPhone is Not Charging:
• Power Button has not been activated; press the
Power Button for 3 seconds and check that the
LEDs light up
• iPhone is not docked correctly on the Lightning
Connector; re-dock the iPhone
• Lightning Connector is damaged; please
contact manufacturer
• Power level of Case is too low; recharge the Case
• The voltage of the device you are attempting to
charge is incompatible; check voltage
specifications
2. Power Case is Not Charging:
• Charging cable/tips are not connected
correctly; re-connect and attempt charging
again
• Charging cable/tips are damaged; please
contact manufacturer
• Charging source is not compatible; check
voltage specifications
PLEASE NOTE
• The Power Case comes pre-packaged with a
partial charge, NOT a full charge. We recommend
fully charging your Case before first use for best
performance.
• If your iPhone is not charging, this may be a sign
that the battery level of the Power Case is very
low and you need to recharge it.
• It is normal for the Power Case to become slightly
warm during use.
MAINTENANCE
I
n order to keep your Power Case operating at
maximum potential, please follow these guidelines:
1.
Recharge the Power Case every 2 months when
not in use. Charge to at least 40%, as this will
extend the battery life.
2.
Keep your Power Case dry and away from moist
and corrosive materials. DO NOT get wet. In
addition, never expose to high heat environments.
Avoid extreme temperatures of hot or cold as it
will decrease the overall battery performance.
SAFETY PRECAUTIONS
Please read this section carefully before using.
• Only use this product with confirmed power
sources that follow device specifications.
• Only use specified charging methods or reputable
branded chargers that are compatible with device
specifications.
• Do not use product beside or in close proximity to
a heat source such as a ventilation heat vent,
convection heater, burner, etc.
• Do not expose device to moisture or submerge it
in liquid. Do not leave device inside an excessively
hot or cold environment. Store device in a cool
and dry environment at all times.
• Avoid dropping or applying excessive shock and
force to device. Do not use in unprotected outdoor
environments or in exposed sunlight for a
prolonged period of time.
• Do not use device in a confined space. Restricted
or insufficient airflow will put device at risk of
overheating.
• Avoid touching metal prongs when plugging and
unplugging device from power source.
• Do not use harsh chemicals to clean device. Use a
damp cloth with warm water to wipe off any dirt.
Only clean the device when it is unplugged from
any power source.
• Ensure charge port is clear of any foreign objects
before using.
• Do not force incompatible connectors into any port.
• Do not used damaged cables and wires on device.
Avoid using cables to charge Power Case other
than supplied for optimal and safe operation.
Supplied cables have gone through rigorous
testing to ensure compatibility.
• Do not attempt to disassemble the device. Any
attempts to do so will void all warranties on this
product. Do not attempt to remove or salvage
batteries for other purposes.
• If you find that your Power Case is excessively hot,
is emitting odor, is deformed, is cut or is
experiencing an abnormal phenomenon,
immediately stop use.
BATTERY PRECAUTIONS
Read all instructions and warnings prior to using this
product. This device contains a Lithium-Polymer
battery. Improper use, storage and disposal may
cause leaks, expansions and explosions that could
lead to fires, health concerns, bodily injury and
property damage.
• Upon the event where the device may be broken,
shattered, or in any way physically compromised
DO NOT USE.
• Do not dispose device into standard garbage
disposal sites. Dispose of device at available
Battery Recycling Sites after fully discharging
battery. Not doing so may violate local disposal
laws and regulations.
• Opening of product and/or removal of battery will
render product inoperative and voids
manufacturer warranties, dispose of remaining
product components in accordance with local
laws.
• If unusual expansion is detected, disuse device
immediately.
• In case of fire, use lithium approved “Class D
Type” Fire Extinguishers on device.
• Do not expose or dispose of device into fire.
• In the unfortunate case of a leak and electrolyte
comes in contact with skin, wash area with water
and soap. If electrolyte makes contact with eyes,
flush with generous amounts of water for 15
minutes and seek medical attention immediately.
Avoid inhaling fumes if applicable. Do not attempt
to reuse damaged device.
• Do not charge device with unspecified power
source. Only use specified method of charge and
reputable brand OEM chargers compatible with
device specifications.
This device has the function of overcurrent and
short-circuit protection circuit. If no reaction to
charge other devices when power is on, please
charge it to activate the device.
FCC STATEMENT
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user authority to operate
the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on. The user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING
INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
CALIFORNIA PROP 65 WARNING
WARNING: This product contains chemicals known to
the State of California to cause birth defects or other
reproductive harm. For more information on these
regulations and a list of chemicals, log on to the
following website address:
http://www.oehha.ca.gov/prop65.html
INNOVATIVE TECHNOLOGY ELECTRONICS CORP.
LIMITED WARRANTY: 90 DAYS LABOR, ONE YEAR PARTS
I
nnovative Technology Electronics Corp. (IT) warrants
the product to be free from “Defects” in materials
under normal use for a period of “One Year” from the
date of the original purchase. The Warranty is “Not”
transferable. IT agrees, within the initial “90 Day”
period, to repair or replace the product if it is
determined to be defective at “No Charge”. It is
further agreed that IT will cover the cost to repair or
replace damaged “Parts” only for a total period of
“One Year” from the date of the original purchase.
The warranty does not cover cosmetic damage,
antennas, AC cords, cabinets, headbands, ear-pads,
or damage due to line power surges, connection to
improper voltage supply or settings, misuse,
mishandling, accident, acts of God or attempted
repair by an unauthorized service agent.
To obtain service, the purchaser MUST present an
original sales receipt / proof of purchase. Please
contact us at www.ithomeproducts.com to request
an RMA (Return Material Authorization) number to
return products for service or replacement. Returns
without an RMA number on the package will be
refused and returned to sender. Upon receipt of the
returning item and our full inspection (IT) may issue
a replacement to customer for the same item or of
one that has equivalent value and features. To return
an item, supply full name, return address, phone
number, item purchased, receipt of purchase and
reason for return to obtain RMA number.
All returns must be in the original packaging or
reasonable substitute to prevent damage. Customer
“Must” include full name, shipping address and
telephone number inside of package. No return will
be shipped back to a PO Box or APO address.
Please include your check or money order in the
amount of:
• USD$5.00 for items $10.00 to $39.99
(Price Paid Per Unit)
• USD$10.00 for items $40.00 to $99.99
(Price Paid Per Unit)
• USD$16.00, for items $100.00 and up
(Price Paid Per Unit)
• Shipping fees are non-refundable
To be payable to Innovative Technology Electronics
Corp.(for handling and return shipping charges) (IT)
will not be responsible for delays or unprocessed
claims resulting from a purchaser’s failure to provide
any / all of the necessary information. Send all
inquiries or RMA request via our website:
www.ithomeproducts.com/support
Innovative Technology Electronics Corp.
1 Channel Drive,
Port Washington, NY 11050
Toll free: 1-877-483-2497
Website for support:
www.ithomeproducts.com/support
There are no express warranties except as listed
above.
REPAIR OR REPLACEMENT AS PROVIDED UNDER
THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE
CUSTOMER, (IT) SHALL NOT BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR
BREACH OF ANY EXPRESS OR IMPLIED WARRANTY
ON THIS PRODUCT EXCEPT TO THE EXTENT
PROHIBITED BY APPLICABLE LAW. ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE ON THIS PRODUCT IS
LIMITED IN DURATION TO THE DURATION OF THIS
WARRANTY.
Some states do not allow the exclusion or limitation
of incidental or consequential damages, or
limitations on how long an implied warranty lasts, so
the above exclusions or limitations may not apply to
you. This warranty gives you specific legal rights and
you may also have other rights, which vary from
state to state.
NOTE: As a result of continual improvements,
the design and specifications of this product
are subject to change without notice.
Apple and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries. Lightning
is a trademark of Apple Inc. iPhone NOT included.
CAN ICES-3 (B) / NMB-3 (B)
Made in China.
7
8
9
