18
2 Preparation
It is easy to permanently adjust the amount of water for all
single
products
to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example:
Proceed as follows to
permanently
set the amount of
water for one coffee.
Precondition:
The start screen is displayed. Milk is connected to the
fine foam frother
T
Place a cup under the coffee spout.
T
Press and
hold
the
‘Coffee’
button until
‘Enough coffee?
Press button’
appears.
T
Release the
‘Coffee’
button.
Preparation starts and the coffee flows into the cup.
T
Press any button (except
‘Cancel’
) as soon as there is
sufficient coffee in the cup.
Preparation stops.
‘Saved’
appears briefly on the display. The
set amount of water for one coffee is permanently stored.
Your JURA is once more ready for use.
E
You can alter this setting at any time by repeating the above
procedure.
E
You can also permanently set the amounts for all single
products in programming mode (see Chapter 4 ‘Permanent
settings in programming mode – Adjusting the product
settings’).
You can adjust the grinder on a continuous scale to suit the degree
of roast of your coffee.
If you adjust the consistency of grind when the grinder is not oper-
ating, the grinder adjustment switch could be damaged.
T
Only adjust the consistency of grind when the grinder is run-
ning.
The consistency of grind is correct if the coffee flows regularly from
the coffee spout. In addition a fine, thick crema forms.
Example:
Proceed as follows to change the consistency of grind
during
the preparation of an espresso.
T
Place a cup under the coffee spout.
Permanently setting the
amount of water for the
cup size
Adjusting the grinder
CAUTION
