Jura 24049, Instructions For Use Manual

Page: 12 / 76

12
Fresh water kit for X8/X6
T Insert the water hose firmly into the valve
block. Check that the water hose is firmly in
place.
E
You may shorten the water hose as required.
E The water connection (to the valve block)
must have been installed at the house end
by a qualified person. Have a qualified
person install the metal hose on the valve
block.
T Connect one of the cables at the fresh water
clip to the valve block cable.
E Use one of the connecting cables supplied, if
required.
T Connect the second cable at the fresh water
clip to the power supply unit cable.
T Insert the power supply unit into a power
socket.
2 Descaling the fresh water clip
Calcium deposits may build up on the fresh water
clip. We recommend descaling the fresh water clip
regularly.
T Close the shut-off valve.
T Disconnect the power supply to the valve
block.
T Immerse the fresh water clip in a descaling
solution (3 JURA descaling tablets in 500 ml
water) for around 20 minutes.
T Rinse the receptacle thoroughly and fill with
fresh water.
T Immerse and remove the clip approximately
10 times to rinse out the remains of the
descaling solution.
E Calcium deposits may build up in the water
tank. For this reason, you should remove
and clean the water tank regularly.
3 LED displays
Status LEDs at the top and side of the fresh water
clip:
U
Light up red: Fresh water clip is not correctly
attached.
U
Do not light up: Not an error; fresh water clip is
working properly.
U
Flash red: Error; the safety switch has been
activated. The water tank will no longer be
filled. Perform descaling. If the error persists,
contact JURA service.