wiJAC-Txx Wireless Intercom System with Transceiver Connection
Operating Manual
Page 7
5.2
Purging
A JA67 that has already been paired with four JA66 headset adapters must be
purged to clear any existing pairings if it is necessary to replace one or more of
the headset adapters. The purging process is described in the following steps:
1. Turn off the JA67 and any other JA66 previously paired with the JA67.
2. Turn on the JA67.
3. The JA67 enters the standby mode (Power Annunciator blinks in sets of two
or three flashes). If the Power Annunciator stays on continuously, there is a
JA66 still powered on and is connected to the JA67. Please turn off the
JA66.
4. On the JA67-001, press and hold the Pair Switch (>8 seconds) until the
Power and Low Battery Annunciators turn off. Release the Pair switch.
5. The JA67 enters the purge mode (Power Annunciator blinks in sets of three
flashes). Wait for the JA67 to finish purging all paired JA67 from its memory
(approximately 10 seconds).
6. Turn off the JA67.
7. Turn on the JA67. If the Power Annunciator blinks in sets of three flashes,
the purging process was successful. If the Power Annunciator blinks in sets
of two flashes, repeat the purging process from step 1.
