wiJAC
-
00x
Wireless Intercom System
Operating Manual
Rev C
Page 5
4.5
Connectors – Both units
4.5.1
IO Configuration Port (Dealers only)
This port is used by Approved dealers and installers to connect the unit to a
laptop or PC to enable configuration changes using the ProCS™ program.
4.5.2
PWR
(Charging Port)
The Charging Port is a Micro-USB connector with a flexible cover labeled
PWR (power) on the left side of the unit. To charge NiMH batteries, connect
a USB (Universal Serial Bus) to Micro USB cable from the Charging Port to
a USB power source.
WARNING:
Charging battery types other than NiMH or NiCad
may cause the batteries to leak or explode and cause damage or
injury. If non-NiMH or non-NiCad batteries are installed, do not
connect the Charging Port to a USB power source.
4.6
Annunciators – Both Units
4.6.1
PWR ON
(Power On)
The power on (PWR ON) annunciator is a green LED located on the right
side of the unit. In addition to indicating that the unit is turned on, this
annunciator indicates the connection status of paired units (see
4.6.2
LOW BATT
(Low Battery Warning)
The low battery (LOW BATT) annunciator is a red LED located on the left
side of the unit. When a unit is turned on, the LOW BATT annunciator will
illuminate for 2 seconds.
When the JA60 battery voltage is low the LOW BATT annunciator will flash
once every 1.5 s and a low battery notification (a triple beep) will be heard in
the headphones once every minute. (A similar but higher pitched tone will be
heard if the paired JA61 Intercom Adapter battery charge is low.)
When the unit battery charge is less than or equal to the critical battery
voltage, the unit will turn off.
4.6.3 Battery Charge (not shown)
The JA60 and JA61 Battery Charge annunciators are two LEDs, one on
each side of the charging port under the flexible dust cover marked PWR.
The Fast Charge annunciator is a red light emitting diode (LED) that will
illuminate when the batteries are being charged at the maximum charge
current.
The Top-Off Charge annunciator is a green LED that will illuminate when
Fast Charge mode is complete and the batteries are charged.