wiJAC
™ Wireless Intercom System
Operating Manual
Rev B
Page 3
WARNING:
If non-NiMH and non-NiCad batteries are installed,
do not connect the Charging Port to a USB power source.
Charging battery types other than NiMH or NiCad may cause the
batteries to leak or explode and cause damage or injury.
3.3
Battery Charge Annunciators
The Fast Charge annunciator is a red light emitting diode (LED) under the
Charging Port cover above the Charging Port connector. The Fast Charge
annunciator is illuminated when the batteries are being charged at the
maximum change current.
The Top Off Charge annunciator is a green LED under the Charging Port
cover below the Charging Port connector. The Top Off Charge annunciator
is illuminated when the batteries are being charged at the minimum charge
current.
3.4
Battery Lid Release
The battery lid release is a lever on the front of the unit recessed into the
battery lid. To remove the battery lid and access to the batteries, push the
release level upwards and then gently pry the lid away from the unit.
3.5
Belt Clip
The belt clip is on the rear of the JA60 Headset Adapter. Clip it to your belt
or place it in another secure location.
3.6
Charging Port (PWR)
The Charging Port is a Micro-USB connector with a cover labeled PWR
(power) on the left side of the unit. To charge NiMH batteries, connect a
USB (Universal Serial Bus)to Micro USB cable from the Charging Port to a
USB power source.
3.7
Configuration Port (IO)
The configuration port is a 3.5 mm 4 pole connector with a flexible cover
labeled IO (input / output) located on the right side of the unit. This port is
used during maintenance.
The Headset and Intercom Adapters are factory configured with default
settings that are suitable for most general aviation requirements. If it is
necessary to change the phones/microphone input /output settings, this can
be performed by a JAC dealer. Find your nearest dealer from the Dealers
section of the JAC website
– www.jupiteravionics.com.
3.8
Headset Jack
The headset jack is a TJT120 type connector on the top of the JA60 headset
adapter. Insert a U-174/U or U93A/U type Headset plug in to the JA60
Headset Adapter's headset jack.
