JUNO JRN 20882, Operating Instructions Manual

Page: 29 / 36

electrolux 29
GB
Installation
Take utmost care when
handling your appliance so
as not to cause any damages
to the cooling unit with
consequent possible fluid
leakages.
During normal operation, the
condenser and compressor at the
back of the appliance heat up
considerably. Always ensure that
there is adequate ventilation as a
failure to do this will result in
component failure and possible
food loss. See installation
instructions.
Important: if the supply cord is
damaged, it must be replaced by a
special cord or assembly available
from the manufacturer or its
service agent.
Positioning
Unpack the cabinet and check that
it is in good condition and free of
any transport damage.
The appliance must not be located
close to radiators or gas cookers.
Avoid prolonged exposure of the
appliance to direct sunlight.
For safety reasons, minimum
ventilation must be as shown in
Fig.
Attention: keep ventilation
openings clear of obstruction.
It is necessary that the niche is
provided with a conduct of venti-
lation having the following
dimensions:
Depth: 50 mm
Width: 540 mm
The climate classification can be
found on the rating plate, which is
located inside the cabinet on the left
hand wall.
The following table shows which
ambient temperature is correct for
each climate classification:
Climate for an ambient
classification temperature of
SN +10 to +32 °C
N +16 to +32 °C
ST +18 to +38 °C
T +18 to +43 °C
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to
your domestic power supply.
Voltage can vary by ±6% of the rated
voltage.
For operation with different voltages,
a suitably sized auto-transformer must
be used.