Problem
Possible cause
Remedy
You cannot activate the outer
ring.
Activate the inner ring first.
There is a dark area on
the multiple zone.
It is normal that there is a
dark area on the multiple
zone.
The sensor fields become
hot.
The cookware is too large or
you put it too near to the
controls.
Put large cookware on the
rear zones if possible.
comes on.
Automatic Switch Off oper-
ates.
Deactivate the hob and acti-
vate it again.
comes on.
The Child Safety Device or
the Lock function operates.
Refer to "Daily use" chapter.
and a number come on.
There is an error in the hob.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an Authorised Service
Centre.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
INSTALLATION
WARNING!
Refer to Safety
chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains cable
12
