JUNO JKI1433 Operating Instructions Manual Download Page 6

19

t

Ice-cube production

This appliance is equipped with one or more trays for
the production of ice-cubes.
Fill these trays with water, then put them in the freezer
compartment.

Do not use metallic instruments to remove the trays
from the freezer.

Defrosting

Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use.
The defrost water drains out through a trough into a
special container at the back of the appliance, over the
motor compressor, where it evaporates.

It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside. Use
the special cleaner provided, which you will find
already inserted into the drain hole.

The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.

Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.

Do not use a mechanical device or any artificial means
to speed up the thawing process other than those
recommended by the manufacturer.

However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
as follows:

1. pull out the plug from the wall socket or turn the 

thermostat knob to the «O» setting;

2. remove any stored food, wrap it in several layers of 

newspaper and put it in a cool place;

3. leave the door open, place a basin on the top shelf 

of the refrigerator compartment, under the drain 
hole, remove the plug as shown in the figure;

4. when defrosting is completed, dry the interior 

thoroughly and refit the plug.

Keep the scraper for future use; turn the thermostat
knob back to the required setting or replace the plug in
the power socket. After two or three hours, reload the
previously removed food into the compartment.

Important

A temperature rise of the frozen food packs, 
during defrosting, may shorten their safe 
storage life.

D037

PR151

Summary of Contents for JKI1433











Reviews: