21
8mm
PR34
Open both the appliance door and that of the kitchen
unit to approx. 90¡. Place the little plates over the
runners. Hold the doors of the appliance and the unit
together and mark the holes.
PR35
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little platee over the
runners and screw in the screws provided (3.5x16
mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that the
doors of the appliance and the kitchen unit open
properly.
Inner door reversal
1) Using a screwdriver release bracket (1) by
pressing on the internal spring (Fig. 11) and
withdraw it from its seat together with the door;
2) remove plug (2) and fit it in the hole left open on
the opposite side;
3) turn the door through 180¡, remove the bracket
(1) and refit it on the opposite side. Refit the door
and insert the top pin and bottom bracket (1),
pushing it into place.
4) To ensure correct storage of food, the door is
fitted with a simple spring device which holds it in
the open position until it is properly closed.
PR140
1
2
180
°