JUNO JKI 2438 Operating Instruction Download Page 6

Maintenance

Unplug the appliance before carrying out
any maintenance operation.

Warning

This appliance contains hydrocarbons in its

cooling unit maintenance and recharging must
therefore only be carried out by authorised
technicians.

¥ When defrosting is completed, dry the interior

thoroughly and refit the plug.

¥ Turn the thermostat knob back to the required

setting or replace the plug in the power socket. 

¥ Reload the previously removed food into the

compartment.

Never use sharp metal tools to scrape off
frost from the evaporator as you could
damage it.
Do not use a mechanical device or any
artificial means to speed up the thawing
process other than those recommended by
the manufacturer.

Defrosting

Refrigerator compartment

¥ Defrosting the refrigerator compartment is

automatic. The defrost water drains out through a
trough into a container at the back of the appliance,
above the motor compressor, where it evaporates.

¥ It is important to periodically clean the defrost

water drain hole.

D037

Freezer compartment

¥ Remove the frost with a plastic scraper.

¥ Whenever the thickness of the frost exceeds 5 mm

complete defrosting should be carried out.

Prooceed as follows:

¥ Remove any stored food, wrap it in several layers

of newspaper and put it in a cool place.

¥ Pull out the plug from the wall socket or turn the

thermostat knob to the ÇOÈ setting.

¥ Leave the door open, place a basin on the top shelf

of the refrigerator compartment, under the drain
hole, remove the plug as shown in the figure.

PR151

Cleaning

Never use metal objects for cleaning your
appliance as it may get damaged.

NEVER use detergents, abrasive powders,
highly perfumed cleaning products or wax
polishes to clean the interior as these will
damage the surface and leave a strong
odour.

Clean the inside with warm water and bicarbonate of
soda. Rinse and dry thoroughly.

To guarantee a safe operation of the fridge, once a
year remove the ventilation grille at the base and
clean the air channels with a vacuum cleaner.

When the appliance is not in use

Disconnect the appliance from the electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.

Changing the light bulb

¥ Should the interior light fail to work, first switch off

the appliance and disconnect from the electricity
supply, then replace the bulb as follows:

1. unscrew the light cover securing screws.
2. unhook the moving part by pressing it as shown

in the figure.

3. Replace the bulb by other with another with the

same charcteristics.

D411

16

Summary of Contents for JKI 2438















Reviews: