12
INSTALLATION
If this appliance featuring magnetic door seals is
to replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance.
This will prevent it from becoming a death-trap for
a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct sun-
light etc.; best performance is obtained with ambient
temperature b18
°
C and +43
°
C (class T);
+18
°
C and +38
°
C (class ST); +16
°
C and +32
°
C (class
N); +10
°
C and +32
°
C (class SN).
The class of your appliance is shown on its rating
plate.
For building into kitchen units follow the special
“Building-in” instructions given.
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate correspond
to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a con-
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio inter-
ference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modifications.
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.
Instructions for totally built-in appliances
Dimensions of housing
Height
1580 mm
Depth
550 mm
Width
560 mm
The appliance doors have been locked in position for
transport by means of pins on both sides.
In case of door opening from the right side, remove
relevant pins at the top and at the bottom.
In case of door opening from the left side, remove
pins at the top and the door, take off the intermediate
hinge and put it on the left side, then fit the door again
and the pin.
Fig. 1
For safety reasons,
minimum ventilation
must be as shown in
Fig. 1.
A t t e n t i o n : k e e p
ventilation open-
ings clear of ob-
struction.
Fig. 2
Push appliance into
housing until stop
strip (A) touches the
kitchen unit.
Fig. 3
If after having carried
out the operation de-
scribed in section 2
there is still some
space left between
the appliance and
the kitchen unit, fit
the trimming provid-
ed together with the
a p p l i a n c e o n t h e
stop strip (A).
D027
50-min. cm
2
200
min.
cm
2
200
A
D023
D265
A
