11
In die Befestigungs- und Scharnierlöcher
beiliegende Abdeckkappen (B) eindrücken.
D
C
D723
D726
B
Tür öffnen und Gerät gegenüber der Bandseite an
die Möbelseitenwand anrücken.Gerät mit den 4 bei-
liegenden Schrauben befestigen.
Belüttungsgitter (C) und Scharnierabdeckung (D)
aufstecken.
Die Schiene (A) auf der Innenseite der Möbeltür
oben und unten auflegen (siehe Abb.) und die
Position der äußeren Bohrlöcher anzeichnen.
Nachdem die Löcher gebohrt wurden, die Schiene
mit den mitgelieferten Schrauben befestigen.
20 mm
A
50mm
PR166
PR266
A
B
C
D
Die Teile A, B, C, D abnehmen, wie in der Abb.
gezeigt wird.
44 mm
Beim Einbau bitte beachten, dass die Gehäusekante
vom Gerät zum Rand des Küchenmöbels einen
Abstand von 44 mm haben muss.
14
CONTENTS
Warnings
.............................................................................................................................................14
Use
- Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration - Freezing ...
fresh food - Storage of frozen food - Thawing - Ice-cube production ...................................................15
Use
- Cold accumulator - Movable shelves - Positioning the door shelves -
Hints
- Hints for refrigeration .....
Hints for freezing.....................................................................................................................................16
Use
- Hints for storage of frozen food -
Maintenance
- Periods of no operation - Periodic cleaning ......
Interior light - Defrosting ........................................................................................................................17
Customer service and spare parts
-
Installation
- Location - Electrical connection .........................18
Installation
- Door reversibility ..............................................................................................................19
Installation
- Building-in instructions.....................................................................................................20
•
Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance.Do not use a
mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer.Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably.For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important:
if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit.It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up.Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss.See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol
are recyclable.
