JUNO JKG 7400 M Operating Instructions Manual Download Page 7

17

Interior light

The light bulb inside the refrigerator compartment
can be reached as follows:

- unscrew the light cover securing screw.

- unhook the moving part as shown in the figure.

If the light does not come on when the door is open,
check that it is screwed into place properly. If it still
does not light up, change the bulb. The rating is
shown on the light bulb cover.

D613

Defrosting

Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use. The defrost
water drains out through a trough into a special
container at the back of the appliance, over the
motor compressor, where it evaporates.

It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
Use the special cleaner provided, which you will
find already inserted into the drain hole.

The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.

However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
as follows:

1. pull out the plug from the wall socket or turn the

thermostat knob to the ÇOÈ setting;

2. remove any stored food, wrap it in several layers

of newspaper and put it in a cool place;

3. leave the door open, and insert the plastic

scraper in the appropriate seating at the bottom
centre, placing a basin underneath to collect the
defrost water.

4. when defrosting is completed, dry the interior

thoroughly; keep the scraper for future use;

5.  turn the thermostat knob back to the required

setting or replace the plug in the power socket.

6.  After two or three hours, reload the previously

removed food into the compartment.

D037

D068

Important: 

Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.

Do not use a maechanical device or any artificial
means to speed up the thawing process other
than those recommended by the manufacturer.

A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.

Summary of Contents for JKG 7400 M










Reviews: