7
Use
The hood may be used as follows:
Exhausting version
The appliance is fitted with 2 exhaust outlets:
one at the top A and the other at the back B
(Fig. 1).
To connect the pipe fit the coupling ring C in
the outlet selected.
Use cover D to close the unused outlet
(Fig. 1).
Remove the exhausting grid (Fig. 2).
Lever E: in position G (Fig. 3).
Refit the exhausting grid.
Choosing the exhausting pipe
The coupling ring C has a diameter of
120mm.
We suggest to use Ø 120 mm exhausting
pipe.
Recycling version
The air is purified by means of a charcoal
filter and recycled into the room through the
front grid.
Remove the exhausting grid (Fig. 2).
Lever E: in position F (Fig. 4).
Refit the exhausting grid.
Mounting the circular charcoal filter
(Fig. 5):
a. Position the circular charcoal filter so
that it covers the plastic grate which
protects the fan wheel and motor.
b. Check that the small tab (1) coincides
with the arrow (2) printed on the conveyor.
c. Turn in clockwise direction.
Installation
When installed, the hood must be not less
than 60 cm. above electric burners or 70
cm. above gas or mixed-fuel burners.
Warning!
— The hood cannot be connected to flues of
other appliances that run on energy
sources other than electricity.
— When the hood is used at the same time
of other appliances that run on energy
sources other than electricity, provision
must be made for an adequate supply of
air.
— No food must be cooked flambé
underneath the hood.
The use of an unprotected flame is
dangerous for the filters and could cause
fires.
Therefore, never use an open flame under
the hood. When frying foods, never leave
the pan alone because the cooking oil
could flare up.
— Please, keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the hood or
its catching on fire because of failure to
observe the above instructions.
Suggestions for the installation and
use of the hood
— The horizontal sections of the pipe must
be slanted slightly upwards (about 10%)
to ensure an easy flow of the air outwards.
— The best performance of the unit is
obtained in the exhausting version,
therefore in the limits of the possibilities
it is advised to use this version.
— The best performances are obtained with
short pipes (max. 4 m) and with few
curves.
Electric connection
Before completing any connection, make
sure the house voltage corresponds with
the voltage indicated on the label affixed
inside the hood.
The hood is supplied with a standard plug;
connect it to a correspondingly standard
socket.
In the case is intended to connect the
appliance permanently to the mains after
having removed the plug supplied, must be
fitted a two-pole switch conforming to
regulations with an opening distance
between contacts of not less than 3mm.
The manufacturers are not liable for any
problems caused by the user’s failure to
observe the above instructions.
