electrolux
37
INSTALLATION
Location
The appliance should be installed
well away from sources of heat such as
radiators, boilers, direct sunlight etc.
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
The a
appliance m
must b
be e
earthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
specialist technician.
The
M
Manufacturer
d
declines
a
all
responsibility iif tthe a
above ssafety
precautions a
are n
not o
observed.
This appliance complies with the
following E.E.C. Directives:
- 8
87/308 E
EEC of 2/6/87 relative to radio
interference suppression.
- 7
73/23 E
EEC of 19.2.73 (Low Voltage
Directive) and subsequent
modifications;
- 8
89/336
E
EEC
of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent
modifications.
ATTENTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
Door reversibility
The a
appliance iis ssupplied w
with
the rright d
door o
opening. T
To c
change
the o
opening d
direction o
of tthe d
door
proceed a
as iin tthe ffollowing
instructions b
before iinstalling iit.
1. Unscrew the upper pin and remove
the spacer
2. Remove the upper door
3. Unscrew the middle hinge and the
plugs and refit them on the opposite
side
4. Refit the upper door, the upper pin
and the spacer on the opposite
side.
