14
Mounting of hood
First set the telescopic support structure on
the right direction and drill as indicated on
the drilling scheme supplied with the hood.
a. The two sections of the structure are fixed
one each other with 8 screws (Fig. 4 - L).
Remove all screws, regulate the lenght of
the structure according the exigencies, fit
again the 8 screws.
In order to install the cooker hood at
the right height consider also that the
height of the body of the hood is 290
and that a minimum distance from
hobs must be in any case respected.
Choose how to use the hood:
Exhausting version
b. Fit a Ø 150 mm exhausting pipe or flex
tube on the ceiling sufficiently long to
reach the connection ring above the hood,
once the hood will be fit on place.
Recirculating version
c. Fit the deflector from one side of the slots
of the upper section of the telescopic
supporting structure (Fig. 5).
Attention!
Slots used must be those perpendicular
to the top fixing points for chimney unit.
d. Fix the deflector with bracket supplied
and 4 screws 2,9x6,5 (Fig. 5).
Fix the deflector also on the other side of
the structure with two other screws same
shape.
e. From the bottom of the telescopic
supporting structure fit the connection
ring supplied (bajonett attachment- turn
clockwise and fix definitively with one
screw 2,9x9,5). (Fig. 6)
f. Fit a section of pipe or flex tube Ø 150 mm
sufficiently long to reach the connection
ring of the hood once this hood will be fit
on place (Fig. 6).
For both versions:
g. Fix the supporting structure to the ceiling
with 4 screws 5x45 and dowel (Fig. 4 - M).
h. Sides with fixing points N for the external
telescopic chimney correspond to the right
and left sides (Fig. 4).
i. The hood is supplied with installation
fittings suitable for most kinds of ceilings,
but in any case a qualified installation
technician must be consulted in order to
choose the best mounting solution.
j. Fix the upper and lower part of the utter
chimney together temporarily with one
screw O 2,9x6,5 (Fig. 7).
k. Fix the upper part of the chimney to the
supporting structure with two screws P
2,9x6,5 (Fig. 7).
l. Fit four auto locking nuts on the four pins
located on the upper side of the hood
(Fig. 8).
m. Fit temporarily the hood on the supporting
structure by means of the already
mentioned pins with nuts to be inserted
on the proper holes located on the lower
side of the supporting structure.
Rotate the hood until it stops (Q - Fig. 9).
n. Completely thighten the nuts (R - Fig. 9).
o. Secure the hood with one screw 4x9,5 (S
- Fig. 9).
p. Fit the electrical plug to the power outlet.
q. Remove the screw that fix the two parts of
the outer chimney together (Fig. 7).
r. Slide the lower part of the chimney
downwards and insert it on its proper
housing on the upper side of the hood
(Fig. 10).
s. Fit the grease filters.
