Juniper TCX1000-RDM20, Hardware Manual

Page: 101 / 206

To set a static IP address on the TCX1000-RDM20 from the CLI:
NOTE: NOTE: You must configure each TCX1000-RDM20 with a unique static
IP address. DHCP should be disabled.
NOTE: You can enter a ? at any time for help.
NOTE: If you want to use IPv4 communication, use step 1 to step 4 , if you
want to use IPv6 communication, use step 5 and step 6 .
1.
Enter the
ip-service show
command to determine the existing IP address and the DHCP
status of the TCX1000-RDM20. See the following sample output.
user@host# ip-service show
CMD_STATUS 0 OK
CMD_RESPONSE 22
config
hostname: host
ipv4
address: 198.51.100.3
netmask: 255.255.255.0
gateway: 0.0.0.0
dhcp enabled: true
ipv6
address: ::
prefix: 128
gateway: ::
enabled: true
state
hostname: host
mac-address: 00:00:5E:00:53:da
ipv4
address: 0.0.0.0
netmask: 0.0.0.0
gateway: 0.0.0.0
dhcp enabled: true
ipv6
link-local address: 2001:db8:0:1:2a0:a502:0:1da
link-local prefix: 64
address: ::
prefix: 0
gateway: ::
enabled: true
STATUS 0 OK
2.
Enter the ip-service config ipv4 enable-dhcp false command to disable DHCP (if
currently enabled).
user@host# ip-service config ipv4 enable-dhcp false
87 Copyright © 2019, Juniper Networks, Inc.
Chapter 15: Performing Initial Configuration