Replacing an AC Power Supply on the SSR1300
IN THIS SECTION
Removing the AC Power Supply from an SSR1300 | 48
Installing the AC Power Supply in an SSR1300 | 49
The two AC power supplies (part number: JNP-650W-AC-SSRHE) are hot-removable and hot-insertable
field-replaceable units (FRUs) installed in the rear panel of the SSR1300 appliance. You can remove and
replace them without powering off the SSR1300 or disrupting the SSR1300 functions.
Ensure that you have the following parts and tools available:
• ESD grounding strap
• Antistatic bag or an antistatic mat
• Replacement AC power supply
Removing the AC Power Supply from an SSR1300
To remove a power supply from the appliance (see
1. If the AC power source outlet has a power switch, set it to the off (0) position and pull out the power
cord connected to the power source outlet.
2. Place the antistatic bag or the antistatic mat on a flat, stable surface.
3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to
the ESD point on the chassis.
4. Pull the power cord retainer down and remove the power cord from the power supply faceplate.
5. Slide the ejector lever towards the right (see
) until the power supply is
unseated.
6. Grasp the power supply handle and pull firmly to slide the power supply halfway out of the chassis.
48
