Juniper SSR120, Hardware Manual

Page: 26 / 87

Console Port Connector Pinouts for SSR120
The console port is an RS-232 serial interface that uses an RJ-45 connector to connect to a console
management device. The default baud rate for the console port is 115200 baud. Table 12 on page 26
provides the pinout information for the RJ-45 console connector. An RJ-45 cable and RJ-45 to DB-9
adapter are supplied with the appliance.
Table 12: Console Port Connector Pinouts
Description Signal Pin
Request to send RTS Output 1
Data terminal ready DTR Output 2
Transmit data TxD Output 3
Ground Ground 4
Ground Ground 5
Receive data RxD Input 6
Data set ready DSR Input 7
Clear to send CTS Input 8
Pluggable Transceivers Supported on SSR120
The 1 GbE RJ-45/SFP combo port on the SSR120 supports the following transceivers:
•
EX-SFP-1GE-SX
•
EX-SFP-1GE-LX
26