Juniper SSG140, Hardware Installation And Configuration Manual, Page: 6 / 60

SSG 140 Series Hardware Installation and Configuration Guide
6 „
Organization
Organization
This guide contains the following chapters and appendixes:
Chapter 1, “Hardware Overview,” describes the chassis and components of the
SSG 140 device.
Chapter 2, “Installing and Connecting the Device,” describes how to mount the
SSG 140 device in a standard 19-inch equipment rack and how to connect cables
and power to it.
Chapter 3, “Configuring the Device,” describes how to configure and manage the
SSG 140 device and how to perform some basic configuration tasks.
Chapter 4, “Servicing the Device,” describes service and maintenance procedures
for the SSG 140 device.
Appendix A, “Specifications,” provides general specifications for the SSG 140
device.
Appendix B, “Initial Configuration Wizard,” provides detailed information about
using the Initial configuration Wizard (ICW) for the SSG 140 device.
Conventions
This guide uses the conventions described in the following sections:
„ “Web User Interface Conventions” on page 6
„ “Command Line Interface Conventions” on page 7
Web User Interface Conventions
The Web user interface (WebUI) contains a navigational path and configuration
settings. To enter configuration settings, begin by clicking a menu item in the
navigation tree on the left side of the screen. As you proceed, your navigation path
appears at the top of the screen, with each page separated by angle brackets.
The following example shows the WebUI path and parameters for defining an
address:
Policy > Policy Elements > Addresses > List > New: Enter the following, then
click
OK :
Address Name: addr_1
IP Address/Domain Name:
IP/Netmask: (select), 10.2.2.5/32
Zone: Untrust
To open online Help for configuration settings, click the question mark (?) in the
upper left of the screen.
The navigation tree also provides a Help > Config Guide configuration page to help
you configure security policies and Internet Protocol Security (IPSec). Select an