Juniper SRX5400, Hardware Manual

Page: 193 / 394

Installing the SRX5400 Services Gateway Routing Engine
To install the Routing Engine into the SCB (see Figure 81 on page 167 ):
NOTE: If you install only one Routing Engine in the service gateway, you must
install it in SCB slot 0 of service gateway chassis.
1.
If you have not already done so, take the host subsystem offline. See “Taking the
SRX5400 Services Gateway Host Subsystem Offline” on page 271 .
2.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
3.
Ensure that the ejector handles are not in the locked position. If necessary, flip the
ejector handles outward.
4.
Place one hand underneath the Routing Engine to support it.
5.
Carefully align the sides of the Routing Engine with the guides inside the opening on
the SCB.
6.
Slide the Routing Engine into the SCB until you feel resistance, and then press the
Routing Engine's faceplate until it engages the connectors.
Figure 81: Installing the Routing Engine
Routing
Engine
g030336
7.
Press both of the ejector handles inward to seat the Routing Engine.
8.
Tighten the captive screws on the right and left ends of the Routing Engine faceplate.
9.
Power on the services gateway. The
OK
LED on the power supply faceplate should
blink, then light steadily.
The Routing Engine might require several minutes to boot.
After the Routing Engine boots, verify that it is installed correctly by checking the RE0
and RE1 LEDs on the craft interface. If the services gateway is operational and the
Routing Engine is functioning properly, the green ONLINE LED lights steadily. If the red
167 Copyright © 2017, Juniper Networks, Inc.
Chapter 19: Installing Additional Components