Juniper SRX340, Hardware Manual

Page: 53 / 150

Related
Documentation
SRX340 Services Gateway Electrical Wiring Guidelines on page 33
•
•
SRX340 Services Gateway Supported AC Power Cords on page 35
SRX340 Services Gateway Supported AC Power Cords
WARNING: The AC power cord for the services gateway is intended for use
with the services gateway only and not for any other use.
NOTE: In North America, AC power cords must not exceed 4.5 m
(approximately 14.75 ft) in length, to comply with National Electrical code
(NEC) Section 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical
Code (CEC) Section 4-010(3).
Table 11 on page 35 provides power cord specifications, and Figure 5 on page 35 depicts
the plug on the AC power cord provided for each country or region.
Table 11: AC Power Cord Specifications
Plug Standards Electrical Specification Country
AS/NZ 3112-1993 250 VAC, 10 A, 50 Hz Australia
GB2099.1 1996 and
GB 1002 1996
(CH1-10P) 250 VAC, 10 A, 50 Hz China
CEE (7) VII 250 VAC, 10 A, 50 Hz Europe (except Italy and United Kingdom)
CEI 23-16/VII 250 VAC, 10 A, 50 Hz Italy
JIS 8303 125 VAC, 12 A, 50 or 60 Hz Japan
NEMA 5-15 125 VAC, 10 A, 60 Hz North America
BS 1363A 250 VAC, 10 A, 50 Hz United Kingdom
Figure 5: AC Plug Types
NOTE: Power cords and cables must not block access to services gateway
components or drape where people might trip on them.
35 Copyright © 2016, Juniper Networks, Inc.
Chapter 9: Power Requirements and Specifications