Juniper SRX100, Hardware Manual

Page: 63 / 154

Chapter 9
Connecting, Grounding, and Powering On
the SRX100 Services Gateway
This chapter includes the following sections:
■
Connecting the SRX100 Services Gateway to the Power Supply on page 45
■
Connecting and Organizing Interface Cables to the SRX100 Services
Gateway on page 46
■
Grounding the SRX100 Services Gateway on page 47
■
Powering On and Powering Off the SRX100 Services Gateway on page 48
Connecting the SRX100 Services Gateway to the Power Supply
To connect the device to the power supply:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to the ESD point on the chassis.
2.
Plug the DC connector end of the power cable into the power connector on the
back of the device (see Figure 11 on page 45).
3.
Plug the AC adapter end of the power cable into an AC power outlet.
Figure 11: Connecting the Services Gateway to Power Supply
CAUTION: We recommend using a surge protector for the power connection.
Connecting the SRX100 Services Gateway to the Power Supply
■ 45