Juniper SRX100, Hardware Manual

Page: 60 / 154

Installing the SRX100 Services Gateway on a Desk
You can install the SRX100 Services Gateway on a desk, table, or other level surface.
The device is shipped with the rubber feet attached. The rubber feet are necessary
to stabilize the device on the desk.
You can install the device in a horizontal or vertical position.
NOTE: The desk-mounting kit is not shipped with the device and must be ordered
separately.
Horizontal Desk Mounting
The horizontal position is the standard installation position and does not require the
vertical installation kit.
To install the device in a horizontal position:
1.
Make sure that the rubber feet are attached to the chassis.
2.
Place the device on a desk with the Juniper Logo facing up.
Vertical Desk Mounting
The vertical position requires the vertical installation kit, which consists of a vertical
installation stand.
To install the device in a vertical position:
1.
Place the device on a flat and level surface with the Juniper Logo facing up, see
Figure 8 on page 42.
Figure 8: Installing the SRX100 Services Gateway on a Desk
42 ■
Installing the SRX100 Services Gateway on a Desk
SRX100 Services Gateway Hardware Guide