Juniper SRX 5800, Hardware Manual

Page: 390 / 536

Replacing the Management Ethernet Cable on an SRX5800 Services
Gateway
One Ethernet cable with RJ-45 connectors is provided with the services gateway.
Before you begin to replace the management ethernet cable:
•
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See “Prevention of
Electrostatic Discharge Damage” on page 505 .
Ensure that you have the following available:
•
ESD grounding strap
To replace the cable connected to the ETHERNET port:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Press the tab on the connector and pull the connector straight out of the port. Figure 150 on page 391
shows the connector.
3. Disconnect the cable from the network device.
4. Plug one end of the replacement cable into the ETHERNET port. Figure 151 on page 391 shows the
port.
5. Plug the other end of the cable into the network device.
Figure 150: Cable Connector
Figure 151: Ethernet Port
391