Juniper QFX5100, Hardware Manual

Page: 198 / 256

NOTE: The switch powers on as soon as power is provided to the power
supply. There is no power switch on the device.
10.
Verify that the
IN
and
OUT
LEDs on the power supply are lit green and are on steadily.
Related
Documentation
DC Power Supply in a QFX5100 Switch on page 37
•
•
DC Power Supply LEDs on a QFX5100 Switch on page 221
Connecting a QFX Series Device to a Management Console
The QFX Series has a console port with an RJ-45 connector. Use the console port to
connect the device to a management console or to a console server.
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an
RJ-45 to DB-9 adapter is provided with the device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the QFX Series, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
device and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.
To connect the QFX Series to a management console (see Figure 44 on page 180 and
Figure 45 on page 180 ):
1.
Connect one end of the Ethernet cable to the console port (labeled CON ).
2.
Connect the other end of the Ethernet cable into the console server (see
Figure 44 on page 180 ) or management console (see Figure 45 on page 180 ).
Figure 44: Connecting the QFX Series to a Management Console Through
a Console Server
Figure 45: Connecting the QFX Series Directly to a Management Console
Copyright © 2014, Juniper Networks, Inc. 180
QFX5100 Switch Hardware Guide