Juniper QFX10016, Hardware Manual

Page: 99 / 439

Other standard interfaces are shown in Figure 42 on page 88 .
Figure 42: RCB Faceplate
1
—
RCB status LEDs 5
—
USB 2.0 port
2
—
Console port 6
—
SATA SSD slot
3
—
PTP-capable connections: SMB In, SMB Out,
10 MHz In, 10 MHz Out 7
—
Reset button
4
—
Ethernet management ports: RJ-45 for
10/100/1000 BASE-T (em0) and small-form
factor pluggable (SFP) for fiber (em1). If both
copper and fiber cables are installed, the
RJ-45 is the default. 8
—
Four SFP+ ports (reserved for future use)
NOTE: You can use either management interface, em0 or em1 when the RCB is running as the
primary RE. Use only em1 when the RCB is running as the backup RE.
QFX10000 Routing and Control Board LEDs
IN THIS SECTION
RCB Status Panel LEDs | 89
QFX10000 Management Port LEDs | 90
SATA SSD LEDs | 92
Virtual Port Connections | 92
88