NOTE: Line cards, the cable management system, and the SATA solid state drive are not part of
the base or redundant configurations. You must order them separately.
NOTE: If you want to purchase additional power supplies (AC or DC), SIBs, or RCBs for your
switch configuration, you must order them separately.
SEE ALSO
QFX10016 Chassis Physical Specifications | 166
QFX10000 Hardware and CLI Terminology Mapping
This topic describes the hardware terms used in QFX10000 documentation and the corresponding
terms used in the Junos OS CLI. See
.
Table 4: CLI Equivalents of Terms Used in Documentation for QFX10000 Switches
Hardware
Item (CLI)
Description (CLI)
Value (CLI)
Item In Documentation
Additional Information
Chassis
QFX10008
QFX10016
–
Switch chassis
QFX10008 Physical
Specifications
and
"QFX10016 Chassis
Physical Specifications"
on page 166
Routing and
Control
Board
CB (
n
)
n
is a value in the range
of 0–1.
Multiple line items
appear in the CLI if
more than one RCB
(CB) is installed in the
chassis.
QFX10000 Routing
and Control Board
20
Summary of Contents for QFX10016
